If you in desperate need of waterproofing a basement, but don’t want to spend big dollars or hours to get the job done, here’s a few pointers to help get you going.

What is basement waterproofing and how does it work? Let’s take a look at the time and tested waterproofing of basement and how it works.

If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens. A big hole in the ground is dug, the footer or foundations are laid, the walls of the basement are built and then the rest of the house follows.

The important point to note is the first one in the list above - that big hole in the ground.

When the walls of the basement are built, there is always a gap left outside the walls which needs to be filled. Loose backfill is what is used to fill this void. No matter how well the backfill is compacted, it is still backfill and water seeks the places of little resistance.

This area is going to have water constantly seeping into it. Typical ways of waterproofing a basement utilize water drainage pipes that often become silted. As the water comes it brings all sorts of suspension with it and that is to be expected as it is natural. Allowing these pipes to fill up, can result in an overload of the system, which can be catastrophic to the basement’s outside walls. So while the walls of the basement may be waterproofed in some way, water, as you probably already know, will usually find a way through the tiniest of gaps.

This type of problem doesn’t usually go away because the pipes that are supposed to take away the excess water gradually worsen over time.

A lot of the time a huge mistake is made by not providing access to these pipes. In an attempt to keep excess moisture out basement waterproofing also can be put onto the outer walls of the basement. This is often referred to as a tanked system.

A better basement waterproofing system, such as the drained cavity basement waterproofing, works by getting rid of the water pressure on the walls. To move water away from your property; it first must be collected and sent through drainage channels to a sump pump or a natural drainage field.

Waterproofing a basement is when they are installed internally, have easy access ports for removing silt, and can be installed in basements where other methods have failed.

So to summarise, good basement waterproofing will:

• not disturb landscaping, decks, patios, driveways, etc
• usually be an approved waterproofing method for home loans
• often be substantially cheaper than other waterproofing methods
• usually be a permanent or long-term solution
• stop both ways by which water can enter through the walls and up from the floor

Choose a reputable basement waterproofer when protecting your home, remember it is economically foolish not to waterproof, because the increased value from waterproofing will definitely exceed the cost of the waterproofing.

In conclusion, you want a basement waterproofing system that will deliver:

• not disturb the exterior appearance of your home
• an approved method by home loan lenders
• more affordable than other methods
• a permanent or long term fix
• stop water through the floor and walls

Waterproofing your home is an investment in its value.

As you can see, the problem of basement waterproofing is not uncommon and there are steps that can be taken to make your life a lost easier when dealing with it.

Tags: General //